Doepfer A-190-1 MIDI-CV/Gate/Sync Interface Uživatelský manuál stáhnout pdf (Strana 4)

A-190

MIDI-CV/SYNC Interface

System A - 100

doepfer

3. Starting to use the A-190

Before switching your system on, use a MIDI cable to

connect between your MIDI instrument and the A-190:

D Connect the A-190’s input socket MIDI IN " to the

MIDI OUT socket of your MIDI instrument (master

keyboard, MIDI synth, MIDI sequencer, etc.).

Now switch your System A-100 on. The Gate LED

7 will briefly light up, to show you the A-190’s

software version (one blink = Version 1, etc.).

D Patch the outputs of your A-190 to corresponding

modules on the System A-100:

The

gate output

and

CV1 output

are automa-

tically connected to the system bus of the A-100, so

don’t use patch cables to connect these, unless you

have cut the links, or wish to connect to a module

whose system bus isn’t connected with the A-190’s

(have a look at the note on using more than one

A-190). VCOs on the same system bus automati-

cally receive CV1, and ADSRs automatically re-

ceive the gate signal.

Use the CONFIG and PERFORM menus to tailor

the MIDI set-up to your requirements.

A N.B. if you’re using more than one A-190:

The A-190 is normally connected up to the INT.CV und

INT.GATE on the system bus.

If you want to run

more than one A-190

with only a

single system bus, then only one of the A-190s must be

connected to the system bus.

Disconnect the other A-190 modules from the system

bus, by cutting the

two

links labelled

CV1

and

GATE

(near the bus ribbon connector on the A-190 board).

Output Connection notes

CV 2 Any module’s CV input (for instance a

VCF’s CV input, for controlling the filter

cut-off point).

§ Clock For instance, the A-160’s trigger input for

MIDI-synced sequences.

Reset The A-160’s reset input, for MIDI control of

start and stop messages;

the A-140’s gate or retrigger input for

MIDI-synchronised envelopes.

1 2 3 4 5 6 7 8 9 ... 21 22

Komentáře k této Příručce

Žádné komentáře

Doepfer A-190-1 MIDI-CV/Gate/Sync Interface Uživatelský manuál Strana 4

Komentáře k této Příručce

Související produkty a manuály pro Audio Doepfer A-190-1 MIDI-CV/Gate/Sync Interface